Industrial polyurethane floor paint

Product Introduction
This product is a two-component coating composed of modified resin, weather-resistant pigments, wear-resistant fillers, imported additives, and non-yellowing curing agent. It features excellent adhesion, good weather resistance, and fast drying.

Product Uses
Suitable for outdoor sidewalks, children's playgrounds, basketball courts, outdoor parking lots, etc.

Product Features

1. Excellent adhesion, suitable for various substrates.

2. Good weather resistance.

3. Fast drying speed.

4. Good abrasion resistance and water resistance.

Physical Properties

Surface Preparation

1. Substrate moisture content must be below 8%. The substrate must be fully treated, kept clean and dry before application; remove dust, oil, acid, alkali, and water. The underlying coating must be dry and dense before applying topcoat.

2. Dust removal: Use compressed air to blow clean, or sweep with a clean broom.

Application Conditions
Optimal application temperature is 5℃ to 30℃. Relative humidity must be below 80%. Avoid application in rain, snow, or fog. Contact with water is prohibited. Provide adequate ventilation during application and curing in confined spaces. The substrate surface must be dry and clean, with temperature at least 3℃ above the dew point.

Application Methods
Air spraying or roller coating. If special methods (such as airless spray or brush) are required, please notify in advance so the company can adjust the formulation accordingly.

Application Parameters

1. Mixing ratio: Follow the ratio indicated on the packaging. Use a power stirrer to thoroughly mix the base material.

2. Thinner: Eco-friendly Type 1 thinner.

3. Thinning ratio: Generally 5–15% of the base paint volume.

4. Pot life: Use within 3 hours after mixing (at 23±2℃). Generally, the pot life halves for every 10℃ increase in temperature, and doubles for every 10℃ decrease.

5. Induction time: After mixing components A and B at the specified ratio, stir with a power mixer for about 5 minutes before application.

6. Spray pressure: 0.4–0.6 MPa (air spraying).

7. Tool cleaning: Eco-friendly Type 1 thinner.

8. Recoat interval: Minimum recoat interval: 10 h; Maximum recoat interval: 168 h (under standard conditions).

Recommended Supporting Products
Epoxy floor intermediate paint, various epoxy floor sealing primers, etc. For other supporting products, please consult our company's floor coating department.